K.T.S Crane equipped with K.T.S Arm Cutter
The idea behind the K.T.S timber trailer concept is that the crane and the trailer should be as versatile as possible. An investment which enables you to load timber, dig and cut roadsides constitutes a greater value. You could use your investment for many purposes and all year round.

K.T.S Crane 5.3 m

The comfort joint makes it possible to cut in all positions, downhill and uphill, using the full length of the crane and staying close to the tractor.

The cutting head has a working width of 1.33 m. It is manufactured in Italy and it is the same as is used for our flail mowers. How coarse bushes can the K.T.S Arm Cutter handle? It can handle bushes that may be bent with 'some force'. Look at the pictures and you will have some idea.

The rotor is run by a powerful hydraulic engine. Three belts transfer the power to the cutting rotor. K.T.S has chosen three belts for the 1.33 m operating width in order to avoid problems caused by skidding.

In order to protect the arm cutter when running into fixed obstacles, it has been equipped with a gas accumulator on both the slewing and the 1st boom cylinder.

Order a very detailed colour brochure and price list free of charge! Click below!

Contact K.T.S Maskiner

Phone:      +46 19 58 50 10
Fax:  +46 19 57 42 33
E-mail:  info@kts.se

In our attempts to continuously improve our products, K.T.S Maskiner and the manufacturer reserve the right to change the design and specifications of the products whenever they consider it appropriate, and without prior notification.

Reprinting of the text and pictures in this website in its entirety or parts thereof is forbidden, and offenders will be prosecuted.





Reach to the outer edge of the cutting rotor 5.95 m
Working width 1.33 m
Total width of the cutting head 1.47 m
Number of Y-flails on the cutter 20 pairs
Flow on the pump running the cutting rotor 127 l/min when PTO runs at 1 000 rpm
Volume of the tank for the pump  120 litres
Sight glass for level checks Yes / standard
May be equipped with hammer flails Yes / extra equipment; please keep in mind that a hammer flail is always more sensitive to rocks regardless of which arm cutter is being used
Diameter of the cutting rotor shaft 125 mm
Sweeping diameter of the Y-flails 505 mm
Adjustable support roll Yes / standard, adjustable in 2 positions
Diameter of the support roll 125 mm
Adjustable support runners Yes / standard, adjustable in 2 positions
Rock release Yes / standard, with a gas accumulator on slewing and 1st boom
Driving between gear box and cutting rotor 3 belts
Cutting rotor, number of revolutions 2 160 rpm
Recommended power of the tractor; not only the engine power is important here, but also the weight, thus those are approximated values 80 kW / 110 hp
Weight of the crane including the cutting head, 3-point lift and oil tank with oil, without support legs 1 085 kg


The cutting height is adjusted with the support roll and runners on the sides. The roll and the runners will provide useful support while operating the machine.